Section 8. Operation
Keyboard display security bypass does not allow comms access without first
correcting the security code.
Note These features are not operable in CR1000KDs with serial
numbers less than 1263. Contact Campbell Scientific for information on
upgrading the CR1000KD operating system.
8.7.3 Passwords
Passwords are used to secure IP based communications. They are set in various
comms schemes with the .csipasswd file, CRBasic PakBus instructions, CRBasic
TCP/IP instructions, and in CR800 settings.
8.7.3.1 .csipasswd
The .csipasswd file is a file created and edited through DevConfig (p. 103), and
which resides on the CPU: drive of the CR800. It contains credentials
(usernames and passwords) required to access datalogger functions over IP
comms. See CRBasic Editor Help subject Web Service API
for details
concerning the .csipasswd file.
8.7.3.2 PakBus Instructions
The following CRBasic PakBus instructions have provisions for password
protection:
• ModemCallBack()
• SendVariable()
• SendGetVariables()
• SendFile()
• GetVariables()
• GetFile()
• GetDataRecord()
8.7.3.3 TCP/IP Instructions
The following CRBasic instructions that service CR800 IP capabilities have
provisions for password protection:
• EMailRecv()
• EMailSend()
To Next Page
Loading...
