Campbell CR800 Series - Page 27

Table of Contents
27
String and Variable Concatenation ..................... 166
BeginProg / Scan / NextScan / EndProg
Syntax .................................................................................................. 172
Conditional Output ............................................. 173
Groundwater Pump Test ..................................... 174
Miscellaneous Program Features........................ 176
Scaling Array ..................................................... 179
Program Signatures ............................................ 181
Use of Multiple Scans ........................................ 182
Loading Large Data Sets .................................... 183
Array Assigned Expression: Sum Columns
and Rows .............................................................................................. 185
Array Assigned Expression: Transpose an
Array .................................................................................................... 185
Array Assigned Expression: Comparison /
Boolean Evaluation .............................................................................. 186
Array Assigned Expression: Fill Array
Dimension ............................................................................................ 187
Two Data-Output Intervals in One Data Table .. 191
Using TrigVar to Trigger Data Storage .............. 193
Bool8 and a Bit Shift Operator ........................... 196
NSEC — One Element Time Array ................... 199
NSEC — Two Element Time Array .................. 199
NSEC — Seven and Nine Element Time
Arrays................................................................................................... 200
NSEC —Convert Timestamp to Universal
Time ..................................................................................................... 201
Custom Menus ................................................... 212
FieldCal() Zero ................................................... 219
FieldCal() Offset ................................................ 222
FieldCal() Two-Point Slope and Offset .............. 224
FieldCal() Multiplier .......................................... 227
FieldCalStrain() Calibration ............................... 230
Fast Analog Voltage Measurement: Fast
Scan() ................................................................................................... 234
Analog Voltage Measurement: Cluster Burst ..... 235
Dwell Burst Measurement .................................. 236
Measurement with Excitation and Delay ........... 239
Using SDI12Sensor() to Test Cv Command ...... 250
Using Alternate Concurrent Command (aC) ...... 251
Using an SDI-12 Extended Command ............... 253
SDI-12 Sensor Setup .......................................... 254
Conditional Code ............................................... 257
PT100 BrHalf4W() Four-Wire Half-Bridge
Calibration ........................................................................................... 264
PT100 BrHalf4W() Four-Wire Half-Bridge
Measurement ........................................................................................ 265
PT100 BrHalf3W() Three-Wire Half-Bridge
Calibration ........................................................................................... 268
PT100 BrHalf3W() Three-Wire Half-Bridge
Measurement ........................................................................................ 269
PT100 BrFull() Four-Wire Full-Bridge
Calibration ........................................................................................... 271
PT100 BrFull() Four-Wire Full-Bridge
Calibration ........................................................................................... 273