Develop ineo 350 - Page 199

11. Tech. Rep. Mode Field Service Ver. 1.0 Aug. 2005
160
bizhub 200/250/350
Adjustment / Setting
11.5.6 Original Size Detecting Option
11.6 Settings in the Administrator # Initialize
11.7 Settings in the Counter
11.7.1 Checking the counter reading
1. Call the Tech. Rep. Mode to the screen.
2. Touch the [Counter].
3. Touch [Check] and the specific counter key whose reading is to be checked.
11.7.2 Clearing readings of all counters at once
1. Call the Tech. Rep. Mode to the screen.
2. Touch the [Counter].
3. Touch the [Counter Reset].
4. Touch the counter keys to be cleared and then touch [OK].
11.7.3 Clearing the reading of a specific counter
1. Call the Tech. Rep. Mode to the screen.
2. Touch the [Counter].
3. Touch the specific counter key to be cleared and press the Clear key.
If the reading of a wrong counter key has been cleared, press the Interrupt key to undo
the clearing operation.
11.7.4 Paper
Functions • To set whether or not the optional Original Size Sensors are mounted.
Use • Select [Yes] when the optional Original Size Sensors are mounted.
Setting/
Procedure
• The default setting is “No”.
Ye s “ N o ”
Functions • To initialize the administrator number.
Use • To initialize the administrator number (00000000).
Setting/
Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch the [Administrator # Initialize].
3. Select [Yes] and touch [Enter].
Functions
• To display the number of sheets used for each paper size and each paper type.
To clear the data for any counter.
Use
Setting/
Procedure
Checking the counter reading
☞ 160
Clearing the counter reading (all and a specific one)
☞ 160