5.5 Copy Mode Settings
145
5
System Administration Mode Settings
9. Output Destination
Set the default output destination during copying or printing. This item is displayed when the finisher
or Face Up Side Tray is installed.
Enter the setting values using the numeric keypad referring to the table below.
(Default is 0 as Center Output Tray.)
When Tray 5 (Bypass) is set at 6. Paper Supply, and Finisher Tray is set at 9. Output Destination, the Paper
Supply setting in the Basic Copying screen is set to Auto.
10. Margin Shift - Side 1
Set the default of Side 1 under Margin Shift in the Added Features screen.
Enter the setting values using the numeric keypad referring to the table below.
(Default is 0 as No Shift.)
For details about the Margin Shift, see “3.8 Moving the Position of Images in the Copy - Margin Shift” (P. 333)
in “Part 2 Copier”.
Setting Value Description
0 Center Output Tray
1 Side Output Tray
2 Finisher Tray
Setting Value Description
0No Shift
1 Auto Center
2 Corner Shift (Top Right)
3 Corner Shift (Bottom Right)
4 Corner Shift (Top Left)
5 Corner Shift (Bottom Left)
6 Corner Shift (Top Center)
7 Corner Shift (Bottom Center)
8 Corner Shift (Left Center)
9 Corner Shift (Right Center)
To Next Page
Loading...
Need help?
General
