6.6 Printing Reports/Lists
228
6
Managing Totals and Outputting Reports
■Erroneous Completion of Jobs
The following completion details are sometimes printed at “Job Processing Sta-
tus”:
Printed Details Cause and Remedy
Print parameter in error “Cause” An illegal print parameter combination was set. For
example a non-standard size was specified, and
Tray Selection was set to Auto.
“Remedy”Check the print data. In the above case, select tray
5 (Bypass Tray).
Insufficient print page
buffer
“Case” PCL print data could not be processed as there was
insufficient space in the printer page buffer.
“Remedy” Take one of the following actions:
●
Set Print Mode to Speed Priority.
●
Use Ensure Print.
●
Increase the size of the print page buffer.
●
Add on memory.
See the descriptions under “Part 1 Printer” in the User Guide
(Printer/Scanner).
About print page buffer, “1.5 Memory Allocation”.
For details about the Ensure Print, see the Online Help of the
printer driver for details.
Unexpected error “Cause” An error occurred during print processing.Printing
was instructed by automatic tray selection when
Paper Type Priority is set to Automatic Tray witch-
ing Off for all paper in the Common Settings.
“Remedy” When printing by automatic tray selection, set one
of the paper types to a setting other than Automatic
Tray witching Off in Paper Type Priority.
See “ Paper Type Priority” (P. 129) in “5.4.4 Setting Paper
Tray Attributes”.
Print language automatic
recognition error
“Cause” The print language cannot be automatically selected
when the print mode specified is set to Auto. Prob-
able causes are as follows:
PostScript data was sent without the PostScript
®
Software Kit installed.
“Remedy” The PostScript
®
Software Kit must be installed.
Insufficient hard disk space “Cause” Printing is not possible due to insufficient hard disk
space.
“Remedy” Reduce the number of pages of print data, for
example, by dividing up the print data or printing
one copy at a time when making multiple copies.
PJL command error “Cause” A PJL command syntax error occurred.
“Remedy” Either confirm the print settings, or correct the PJL
command.
To Next Page
Loading...
Need help?
General
