6.6 Printing Reports/Lists
229
6
Managing Totals and Outputting Reports
PostScript error “Cause” An error occurred during PostScript processing.
“Remedy” Take one of the following actions:
●
Set Print Mode to Speed Priority.
●
Increase the size of the print page buffer.
●
Increase PostScript memory.
See the descriptions under “Part 1 Printer” of the User Guide
(Printer/Scanner).
For Print Mode, see the Online Help of the printer driver for
details, and for print page buffer and PostScript memory, see “1.5
Memory Allocation”.
Image development error “Cause” An error occurred during image processing.
“Remedy” Set the Print Mode to Speed Priority and instruct
printing again. If this does not remedy printing, print
in the Ensure Print mode.
For details about the Print Mode and Ensure Printing, see the
Online Help of the printer driver for details.
Print language not installed “Cause” A print language not installed on the machine was
specified. Probable causes are as follows:
PCL data was sent when PCL under Print Mode
Specification was not selected in the network
settings.
“Remedy” For , select PCL.
See “5.7.1 Allocate Memory” (P. 167)
Illegal page margin value “Cause” There are too many paper margin values for the HP-
GL/2 effective coordinate area.
“Remedy” Reduce the paper margin values, and instruct it to
print again.
HP-GL/2 memory overflow “Cause” A probable cause is that the correct document size
could not be judged as the receive data exceeded
the HP-GL/2 spool size.
“Remedy” Wait for processing of print data in memory to end,
and instruct it to print again.
Form and paper size/orien-
tation mismatch
“Cause” The size and orientation of the specified PCL form
do not match that of the paper to print on.
“Remedy” Match the size and orientation of the paper size to
the specified PCL form, and instruct it to print
again.
No plot data in page “Cause” There is no plot data in the HP-GL/2 print data.
“Remedy” Check the print data.
Printed Details Cause and Remedy
1
1
To Next Page
Loading...
Need help?
General
