131
6
Chapter 6 Starting and Stopping Measurement
The instrument is capable of two measurement methods: computer based mea-
surement which allows for the instrument to be controlled from a computer and
data to be collected and observed in real time, and standalone measurement
which allows for data to be saved to a CF card inserted in the instrument. With
either of these methods, use the supplied software Logger Utility to set and send
the measurement conditions.
Starting and Stopping
Measurement Chapter 6
Save data to the CF card
Obtain and save data
in real time
Computer Based Measurement (p. 135)
Standalone Measurement (p. 137)
Start measurement with the button
of Logger Utility
Stop measurement with the button
Disconnect the communication cable from the
instrument
Start measurement with of the
Memory HiLogger
Stop measurement with
Load and display the measurement data
on the computer
The measurement conditions are also set and sent from a computer when you
perform standalone measurement. When you have finished setting all of the
measurement conditions, click the
[Send] button in the settings screen.
To Next Page
Loading...
