CLI Commands: Base
102
4.6
Management Commands
CLI L2P
Release
7.0
05/2011
4.6.10 bridge fast-link-detection
This command enables or disables the Bridge Fast Link Detection.
Default
Enabled
Format
bridge fast-link-detection {disable|enable}
Mode
Global Config
4.6.11 bridge duplex-mismatch-detect operation
This command enables or disables Bridge Duplex Mismatch Detection.
Reasons for Duplex Mismatch can be:
- A local port is configured to fix full-duplex.
- A port is configured to auto-negotiation and has negotiated HalfDuplex-
Mode.
Duplex Mismatch can be excluded, when the local port is configured to auto-
negotiation and duplex mode is negotiated to full-duplex.
Note: If counters and configuration settings indicate a Duplex Mismatch, the
reason can also be a bad cable and/or EMI.
Default
Enabled
Format
bridge duplex-mismatch-detect operation
{disable|enable}
Mode
Global Config
To Next Page
Loading...
Need help?
General
