322
4.12
LLDP - Link Layer Discovery Protocol
CLI L2P
Release
7.0
05/2011
4.12.28lldp hm-mode
Configure the port's LLDP Hirschmann mode (if LLDP/IEEE802.1AB frames
will be transmitted to and/or received from the Hirschmann-specific multicast
address 01:80:63:2f:ff:0b).
The default setting is tx-and-rx.
Format
lldp hm-mode <{tx-only|rx-only|tx-and-rx|off}>
Mode
Interface Config
4.12.29lldp max-neighbors
Configure the port's LLDP max. no. of neighbors (min.: 1, max.: 50,
default: 10).
Format
lldp max-neighbors <1..50>
Mode
Interface Config
4.12.30lldp med
LLDP for Media Endpoint Devices (LLDP-MED) is an extension to LLDP that
operates between endpoint devices such as IP phones, Voice / Media Gate-
ways, Media Servers, IP Communications Controllers or other VoIP devices
or servers, and network devices such as switches. It specifically provides
support for voice over IP (VoIP) applications. In this purpose, it provides an
additional set of common advertisement messages (TLVs), for capabilities
To Next Page
Loading...
Need help?
General
