CLI Commands: Switching
410
5.1
Spanning Tree Commands
CLI L2P
Release
7.0
05/2011
5.1.12 spanning-tree configuration name
This command sets the Configuration Identifier Name for use in identifying
the configuration that this switch is currently using. The <name> is a string of
at most 32 characters.
Default
The base MAC address displayed using hexadecimal notation as
specified in IEEE 802 standard.
Format
spanning-tree configuration name <name>
Mode
Global Config
U no spanning-tree configuration name
This command resets the Configuration Identifier Name to its default.
Format
no spanning-tree configuration name
Mode
Global Config