276
4.10
User Account Management Commands
CLI L2P
Release
7.0
05/2011
4.10.10users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login
user. The valid authentication protocols are none, md5 or sha. If md5 or sha are
specified, the user login password is also used as the snmpv3 authentication
password and therefore must be at least eight characters in length. The
<username> is the login user name associated with the authentication pro-
tocol.
Default
no authentication
Format
users snmpv3 authentication <username> <none | md5
| sha>
Mode
Global Config
U no users snmpv3 authentication
This command sets the authentication protocol to be used for the speci-
fied login user to none. The <username> is the login user name for
which the specified authentication protocol will be used.
Format
users snmpv3 authentication <username>
Mode
Global Config
To Next Page
Loading...
Need help?
General
