Hirschmann MACH 1000 Reference Manual

CLI L2P
Release 7.0 05/2011
4.9 Device Configuration Commands
239
4.9.79 snmp trap link-status
This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
See ‘snmp-server enable traps linkmode’ command.
Format
snmp trap link-status
Mode
Interface Config
U no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is en-
abled. See ‘snmp-server enable traps linkmode’ command).
Format
no snmp trap link-status
Mode
Interface Config

Hirschmann MACH 1000 Specifications

General

Brand	Hirschmann
Model	MACH 1000
Category	Switch
Language	English