180
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.12 monitor session <session-id>
This command configures a probe port and a monitored port for monitor ses-
sion (port monitoring). The first slot/port is the source monitored port and the
second slot/port is the destination probe port. If this command is executed
while port monitoring is enabled, it will have the effect of changing the probe
and monitored port values.
Format
monitor session <session-id>
[mode | {source | destination}
interface <slot/port>]
Mode
Global Config
destination
Configure the probe interface.
mode
Enable/Disable port mirroring session.
Note: does not affect the source or destination interfaces.
source
Configure the source interface.
session-id
Session number (currently, session number 1 is supported).
U no monitor session <session-id>
This command removes the monitor session (port monitoring) designa-
tion from both the source probe port and the destination monitored port
and removes the probe port from all VLANs. The port must be manually
re-added to any desired VLANs.
Format
no monitor session <session-id> [mode]
Mode
Global Config
session-id
Session number (currently, session number 1 is supported).
To Next Page
Loading...
Need help?
General
