CLI Commands: Base
164
4.7
Syslog Commands
CLI L2P
Release
7.0
05/2011
4.7.9 logging snmp-requests set operation
This command enables or disables the logging of SNMP SET requests.
Default
Disabled
Format
logging snmp-requests set operation
{ enable | disable }
Mode
Global Config
4.7.10 logging snmp-requests get severity
With this command you can define the severity level of logging SNMP GET
requests.
Default
Disabled
Format
logging snmp-requests get severity <level|[0-7]>
Mode
Global Config
level | [0-7]
Enter Logging Severity Level (emergency|0, alert|1, critical|2, error|3,
warning|4, notice|5, info|6, debug|7).
Note: selecting a lower severity level (larger number) will include all
messages from higher severity levels (smaller numbers).
To Next Page
Loading...
Need help?
General
