CLI L2P
Release
7.0
05/2011
4.14
PTP - Precision Time Protocol
359
4.14.12ptp v1 subdomain-name
Configure the PTPv1 (IEEE1588-2002) specific settings.
Enter a Precision Time Protocol subdomain name. The default is "_DFLT".
Note: changes are only applied after the 're-initialize' command or after a re-
boot if the configuration was saved.
Format
ptp v1 subdomain-name <subdomain name>
Mode
Global Config
<subdomain name>
Enter a PTP subdomain name (up to 16 characters). Valid characters
range from hex value 0x21 (!) up to and including hex value 0x7e (~).
Enter special characters (\, !, ', ", ?) by preceding them with the
escape character (\), e. g., as \\, \!, \', \", \?. The subdomain name
must not be empty. The default is "_DFLT".
To Next Page
Loading...
Need help?
General
