CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
111
4.6.18 show digital-input <slot/input>
This command shows the IO-Module value or configuration for a single input.
Format
show digital-input <slot/input>
{all | config | value}
Mode
Global Config
all
Show the IO-Module configuration and value for one input.
config
Show the IO-Module configuration for one input.
value
Show the IO-Module value for one input.
Digital Input <slot/input> Value
Show the value of the IO-Module digital input.
Possible values: Not available, High, Low.
Digital Input <slot/input> Log-Event
Show if Event logging is enabled or disabled for the IO-Module digital
input. Possible values: Disabled, Enabled.
Digital Input <slot/input> SNMP-trap
Show if SNMP traps are enabled or disabled for the IO-Module digital
input. Possible values: Disabled, Enabled.
To Next Page
Loading...
Need help?
General
