Hirschmann MACH 1000 Reference Manual

CLI Commands: Base
CLI L2P
Release 7.0 05/2011
4.6 Management Commands
105
4.6.14 digital-output
This command configures the IO-Module digital outputs.
Format
digital-output
admin-state {enable | disable}
refresh-interval <refresh-interval>
retry-count <refresh-interval>
log-event {all | <slot/output>} {enable|disable}
snmp-trap {all | <slot/output>} {enable|disable}
mirror all | <slot>/<output> {disable |
from <IPaddress> <slot>/<input>}
Mode
Global Config
admin-state
This command enables or disables the polling task for digital outputs
of the MICE IO-Module. When disabled, no event logging or SNMP
traps will work. Default: disable.
disable Disable the IO-Module digital outputs admin state.
enable Enable the IO-Module digital outputs admin state.
refresh-interval
This command configures the IO-Module digital outputs refresh
interval. Each output configured for input mirroring is refreshed (input
is polled) with this interval.
<refresh-interval> The refresh interval is in the range of 1..10
seconds. Default: 1.
retry-count
This command configures the number of retry counts for setting digi-
tal outputs of the MICE IO-Module. Each output configured for input
mirroring is set to the default value (low) when after the number of
configured retries no SNMP get request was answered.
<refresh-interval> The refresh interval is in the range of 1..10
seconds. Default: 1.
log-event
This command enables or disables the event logging of output status
changes for one or all digital outputs. Default: disable.
The output state will be checked according to the interval set with IO-

Hirschmann MACH 1000 Specifications

General

Brand	Hirschmann
Model	MACH 1000
Category	Switch
Language	English