CLI L2P
Release
7.0
05/2011
4.9
Device Configuration Commands
177
4.9.9 macfilter
This command adds a static MAC filter entry for the MAC address <macad-
dr> on the VLAN <vlanid>. The <macaddr> parameter must be specified as
a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to
01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF.
The <vlanid> parameter must identify a valid VLAN (1 to 4042) .
Up to 100 static MAC filters may be created.
Format
macfilter <macaddr> <vlanid>
Mode
Global Config
U no macfilter
This command removes all filtering restrictions and the static MAC filter
entry for the MAC address <macaddr> on the VLAN <vlanid>. The
<macaddr> parameter must be specified as a 6-byte hexadecimal num-
ber in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN (1 to 4042).
Format
no macfilter <macaddr> <vlanid>
Mode
Global Config
To Next Page
Loading...
