CLI Commands: Switching
462
5.6
Port Security
CLI L2P
Release
7.0
05/2011
5.6.3 port-sec mode
Configure the global MAC/IP Based Port Security mode:
D ip-based Port security is based on a given, allowed source IP address.
D mac-based Port security is based on a given, allowed source MAC
address.
Format
port-sec mode <{ip-based|mac-based}>
Mode
Global Config
5.6.4 port-sec action
Configure the action to be taken if port security is violated at this port.
D none No action is taken if port security is violated at this port.
D port-disable The port is disabled for traffic if port security is violated.
D trap-only A trap is sent if port security is violated at this port (this port
remains open for traffic).
Configure the allowed IP source address for this port.
Configure the allowed MAC source address for this port.
Format
port-sec {action {none|port-disable|trap-only}
|allowed-ip <IP1> [IP2 [IP3 [IP4 [IP5
[IP6 [IP7 [IP8 [IP9 [IP10]]]]]]]]]
|allowed-mac <MAC1> [MAC2 [MAC3 [MAC4
[MAC5 [MAC6 [MAC7 [MAC8 [MAC9
[MAC10]]]]]]]]] }
Mode
Interface Config
To Next Page
Loading...
Need help?
General
