CLI Commands: Security
518
6.1
Security Commands
CLI L2P
Release
7.0
05/2011
6.1.29 radius server timeout
This command sets the timeout value (in seconds) after which a request must
be retransmitted to the RADIUS server if no response is received. The
timeout value is an integer in the range of 1 to 30.
Default
6
Format
radius server timeout <seconds>
Mode
Global Config
U no radius server timeout
This command sets the timeout value (in seconds) after which a request
must be retransmitted to the RADIUS server if no response is received,
to the default value, i.e. 6.
Format
no radius server timeout
Mode
Global Config
To Next Page
Loading...
Need help?
General
