CLI L2P
Release
7.0
05/2011
4.17
Port monitor
391
4.17.11port-monitor condition crc-fragment
(Interface Config)
Use this command to enable or disable crc-fragment settings on a port to
trigger an action.
Default
Disable
Format
port-monitor condition crc-fragment
{enable | disable}
Mode
Interface Config
4.17.12port-monitor action
Use this command to configure the Port Monitor action (disable a port or send
a trap).
Note: Disable the Port Monitor action will reset the port from port-state.
Default
Enable
Format
port-monitor action {port-disable | trap-only}
Mode
Interface Config
port-disable
Disable the port when the configured Port Monitor condition triggers.
trap-only
Send a trap when the configured Port Monitor condition triggers.
To Next Page
Loading...
Need help?
General
