CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
141
4.6.54 snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address
is the associated community SNMP packet sending address and is used
along with the client IP address value to denote a range of IP addresses from
which SNMP clients may use that community to access the device. A value
of 255.255.255.255 will allow access from only one station, and will use that
machine's IP address for the client IP Address. A value of 0.0.0.0 will allow
access from any IP address. The name is the applicable community name.
Default
0.0.0.0
Format
snmp-server community ipmask <ipmask> <name>
Mode
Global Config
U no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0.
The name is the applicable community name. The community name may
be up to 32 alphanumeric characters.
Format
no snmp-server community ipmask <name>
Mode
Global Config
To Next Page
Loading...
Need help?
General
