Hirschmann MACH 1000

388
4.17 Port monitor
CLI L2P
Release 7.0 05/2011
4.17.6 port-monitor (Global Config)
Use this command to enable or disable the Port Monitor globally.
Note: This command does not reset the port disable states.
Default
Disable
Format
port-monitor {enable | disable}
Mode
Global Config
4.17.7 port-monitor (Interface Config)
Use this command to enable or disable the Port Monitor on the port.
Note: This command does not reset the port disable states.
Default
Disable
Format
port-monitor {enable | disable}
Mode
Interface Config