CLI Commands: Security
510
6.1
Security Commands
CLI L2P
Release
7.0
05/2011
6.1.20 dot1x timeout guest-vlan-period
Use this command to configure the timeout value for the guest-vlan-period.
The time, in seconds, for which the authenticator waits to see if any EAPOL
packets are received on a port before authorizing the port and placing the
port in the guest vlan (if configured). The guest vlan timer is only relevant
when guest vlan has been configured on that specific port.
Default guest-vlan-period: 90 seconds.
Default
90
Format
dot1x timeout guest-vlan-period <seconds>
Mode
Interface Config
<seconds>
Enter an integer in the range of 1-300.
U no dot1x timeout guest-vlan-period
The ‘no’ form of this command resets the timeout value for the guest-vlan-
period to its default value (90 seconds).
Format
no dot1x timeout guest-vlan-period
Mode
Interface Config
To Next Page
Loading...
Need help?
General
