200
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.37 set igmp
This command enables IGMP Snooping on the system. The default value is
disable.
Note: The IGMP snooping application supports the following:
D Global configuration or per interface configuration.
D Validation of the IP header checksum (as well as the IGMP header check-
sum) and discarding of the frame upon checksum error.
D Maintenance of the forwarding table entries based on the MAC address
versus the IP address.
D Flooding of unregistered multicast data packets to all ports in the VLAN.
Format
set igmp
Mode
Global Config
U no set igmp
This command disables IGMP Snooping on the system.
Format
no set igmp
Mode
Global Config
To Next Page
Loading...
Need help?
General
