CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
99
4.6.5 session-timeout
This command sets the telnet session timeout value.The timeout value unit
of time is minutes.
Default
5
Format
session-timeout <1-160>
Mode
Line Config
U no session-timeout
This command sets the telnet session timeout value to the default. The
timeout value unit of time is minutes.
Format
no session-timeout
Mode
Line Config
4.6.6 bridge address-learning
To enable you to observe the data at all the ports, the Switch allows you to
disable the learning of addresses. When the learning of addresses is dis-
abled, the Switch transfers all the data from all ports to all ports. The default
value is enable.
Format
bridge address-learning {disable|enable}
Mode
Global Config
To Next Page
Loading...
Need help?
General
