CLI Commands: Base
96
4.6
Management Commands
CLI L2P
Release
7.0
05/2011
4.6.2 transport input telnet
This command regulates new telnet sessions. If sessions are enabled, new
telnet sessions can be established until there are no more sessions
available. If sessions are disabled, no new telnet sessions are established.
An established session remains active until the session is ended or an
abnormal network error ends the session.
Default
enabled
Format
transport input telnet
Mode
Line Config
U no transport input telnet
This command disables telnet sessions. If sessions are disabled, no new
telnet sessions are established.
Format
no transport input telnet
Mode
Line Config
To Next Page
Loading...
Need help?
General
