CLI L2P
Release
7.0
05/2011
4.9
Device Configuration Commands
193
4.9.30 set garp timer join
This command sets the GVRP join time per port and per GARP. Join time is
the interval between the transmission of GARP Protocol Data Units (PDUs)
registering (or re-registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from
10 to 100 (centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
20
Format
set garp timer join <10-100>
Mode
Global Config
Interface Config
U no set garp timer join
This command sets the GVRP join time per port and per GARP to 20
centiseconds (0.2 seconds). This command has an effect only when
GVRP is enabled.
Format
no set garp-timer join
Mode
Global Config
Interface Config
To Next Page
Loading...
