EasyManuals Logo

Hirschmann MACH 1000 Reference Manual

Hirschmann MACH 1000
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #280 background imageLoading...
Page #280 background image
280
4.11
System Utilities
CLI L2P
Release
7.0
05/2011
4.11.2 cablestatus
This command tests the cable attached to an interface for short or open
circuit. During the test the traffic is interrupted on this port.
Format
cablestatus <slot/port>
Mode
Privileged EXEC
4.11.3 clear eventlog
Clear the event log. The CLI will ask for confirmation.
Answer y (yes) or n (no).
The CLI displays the end of this operation.
Format
clear eventlog
Mode
Privileged EXEC
4.11.4 traceroute
This command is used to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis.
<ipaddr> should be a valid IP address.
The optional port parameter is the UDP port used as the destination of pack-
ets sent as part of the traceroute. This port should be an unused port on the
destination system. [port] should be a valid decimal integer in the range of 0
(zero) to 65,535. The default value is 33,434.

Table of Contents

Other manuals for Hirschmann MACH 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hirschmann MACH 1000 and is the answer not in the manual?

Hirschmann MACH 1000 Specifications

General IconGeneral
BrandHirschmann
ModelMACH 1000
CategorySwitch
LanguageEnglish

Related product manuals