CLI Commands: Switching
450
5.4
Fast-HIPER-Ring
CLI L2P
Release
7.0
05/2011
nodes
Display the number of nodes in the ring for the given Fast HIPER-
Ring ID.
vlan
Display the VLAN ID for the given Fast HIPER-Ring ID.
5.4.3 fast-hiper-ring
Configure the Fast-HIPER-Ring.
Format
fast-hiper-ring {current-id
{mode {ring-manager|ring-switch|rm|rs} |
operation {disable|enable} |
port {primary|secondary} <slot/port> |
ring-name <ring-name> |
nodes <1-n> |
vlan <0-4042>} |
delete-id current-id |
new-id {<id>|default-id}}
Mode
Global Config
current-id
Specify that you want to configure the current Fast-HIPER-Ring ID's
settings.
mode
Configure the switch's Fast HIPER-Ring mode for the given ID (ring-
manager or ring-switch).
rm: Abbreviation for 'ring-manager'.
rs: Abbreviation for 'ring-switch'.
mode ring-manager
Switch is ring-manager for the given Fast HIPER-Ring ID.
To Next Page
Loading...
Need help?
General
