EasyManuals Logo

Hirschmann MACH 1000 Reference Manual

Hirschmann MACH 1000
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #298 background imageLoading...
Page #298 background image
298
4.11
System Utilities
CLI L2P
Release
7.0
05/2011
4.11.23ping
This command checks if another computer is on the network and listens for
connections. To use this command, configure the switch for network (in-
band) connection. The source and target devices must have the ping utility
enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN
(VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends, three pings to the target station.
Format
ping <ipaddr>
Mode
Privileged EXEC and User EXEC
4.11.24signal-contact connection-error
This command configures the signal contact link error monitoring for this port.
Format
signal-contact connection-error {disable|enable}
Mode
Interface Config
disable
A link down event on this port will be not monitored by a signal con-
tact (default).
enable
A link down event on this port will be monitored by a signal contact.

Table of Contents

Other manuals for Hirschmann MACH 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hirschmann MACH 1000 and is the answer not in the manual?

Hirschmann MACH 1000 Specifications

General IconGeneral
BrandHirschmann
ModelMACH 1000
CategorySwitch
LanguageEnglish

Related product manuals