CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
97
4.6.3 transport output telnet
This command regulates new outbound telnet connections. If enabled, new
outbound telnet sessions can be established until it reaches the maximum
number of simultaneous outbound telnet sessions allowed.
If disabled, no new outbound telnet session can be established. An
established session remains active until the session is ended or an abnormal
network error ends it.
Default
enabled
Format
transport output telnet
Mode
Line Config
U no transport output telnet
This command disables new outbound telnet connections. If disabled, no
new outbound telnet connection can be established.
Format
no transport output telnet
Mode
Line Config
To Next Page
Loading...
