CLI Commands: Switching
CLI L2P
Release
7.0
05/2011
5.1
Spanning Tree Commands
411
5.1.13 spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in
identifying the configuration that this switch is currently using. The Configu-
ration Identifier Revision Level is a number in the range of 0 to 65535.
Default
0
Format
spanning-tree configuration revision <0-65535>
Mode
Global Config
U no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in
identifying the configuration that this switch is currently using to the
default value, i.e. 0.
Format
no spanning-tree configuration revision
Mode
Global Config