CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
95
4.6 Management Commands
These commands manage the switch and show current management
settings.
4.6.1 telnet
This command establishes a new outbound telnet connection to a remote
host. The host value must be a valid IP address. Valid values for port should
be a valid decimal integer in the range of 0 to 65535, where the default value
is 23. If [debug] is used, the current telnet options enabled is displayed. The
optional line parameter sets the outbound telnet operational mode as
‘linemode’, where by default, the operational mode is ‘character mode’. The
echo option enables local echo and only takes effect when the local switch is
accessed via the serial connection (V.24).
Format
telnet
<host
> <port>
[debu
g] [li
ne] [
echo]
Mode
Privileged EXEC and User EXEC
To Next Page
Loading...
Need help?
General
