CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.1
System Information and Statistics Com-
71
Signal contact manual setting
closed The signal contact´s manual setting is closed.
open The signal contact´s manual setting is open.
Signal contact operating state
closed The signal contact is currently closed.
open The signal contact is currently open.
Signal contact trap
enabled A trap is sent if the signal contact state changes.
disabled No trap is sent if the signal contact state changes.
Note: To show the signal contact´s port related settings, use the command
show port {<slot/port> | all} (see “show port” on page 226).
4.1.21 show slot
This command is used to display information about slot(s).
For [slot] enter the slot ID.
Format
show slot [slot]
Mode
Privileged EXEC
To Next Page
Loading...
Need help?
General
