Hirschmann MACH 1000 Reference Manual

CLI Commands: Base
112
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.19 show digital-output
This command shows the output value or configuration from all available
digital outputs of the MICE I/O Module.
Format
show digital-output
Mode
Global Config
Digital output System Information:
Admin State
Show the IO-Module digital outputs Admin State.
Possible values: Disabled, Enabled.
Refresh Interval [s]
Show the IO-Module digital outputs Refresh Interval in seconds.
Value range: 1-10.
Retry Count
Show the value of the IO-Module digital outputs Retry count.
Value range: 1-10.
Digital output Information:
Output
Show numbers of the IO-Module digital output.
Possible values (example): 1/1, 1/2, 1/3, 1/4,
3/1, 3/2, 3/3, 3/4
Value
Show the value of the IO-Module digital outputs.
Possible values: Not available, High, Low.
Log-Event
Show if Event logging is enabled or disabled for the IO-Module digital
outputs.
Possible values: Disabled, Enabled.
SNMP-trap
Show if SNMP traps are enabled or disabled for the IO-Module digital
outputs.
Possible values: Disabled, Enabled.

Hirschmann MACH 1000 Specifications

General

Brand	Hirschmann
Model	MACH 1000
Category	Switch
Language	English