CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
135
Port Security (MAC, IP and 802.1X)
Enable/disable sending port security event traps (for MAC/IP port
security as well as for 802.1X).
Spanning Tree Flag
May be enabled or disabled. The factory default is enabled. Indicates
whether spanning tree traps will be sent.
4.6.47 snmp-access global
This command configures the global SNMP access setting (for all SNMP
versions).
Format
snmp-access global {disable|enable|read-only}
Mode
Global Config
disable
Disable SNMP access to this switch, regardless of the SNMP version
used.
enable
Enable SNMP read and write access to this switch, regardless of the
SNMP version used.
read-only
Enable SNMP read-only access to this switch (disable write access),
regardless of the SNMP version used.
To Next Page
Loading...
Need help?
General
