174
4.9
Device Configuration Commands
CLI L2P
Release
7.0
05/2011
4.9.4 cable-crossing
Enable or disable the cable crossing function.
Note: The cable-crossing settings become effective for a certain port, if
auto-negotiate is disabled for this port.
The cable-crossing settings are irrelevant for a certain port, if
auto-negotiate is enabled for this port.
Note: The cable-crossing function is available for the RS20/RS30/RS40,
MS20/MS30, RSR20/RSR30, MACH 1000, PowerMICE and OCTOPUS
devices.
Format
cable-crossing {enable|disable}
Mode
Interface Config
cable-crossing enable
The device swaps the port output and port input of the TP port.
cable-crossing disable
The device does not swap the port output and port input of the TP
port.
To Next Page
Loading...
Need help?
General
