CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
113
Mirror from IP
Show the IP address used for reading the input value.
Possible values: None, a.b.c.d (valid IP address).
Input
Show the input number of the device used for reading the input value.
Possible values (example): 1/1, 1/2, 1/3, 1/4,
3/1, 3/2, 3/3, 3/4
4.6.20 show digital-output config
This command shows the IO-Module digital outputs global configuration.
Format
show digital-output config
Mode
Global Config
Digital output System Information:
Admin State
Show the IO-Module digital outputs Admin State.
Possible values: Disabled, Enabled.
Refresh Interval [s]
Show the IO-Module digital outputs Refresh Interval in seconds.
Value range: 1-10.
Retry Count
Show the value of the IO-Module digital outputs Retry count.
Value range: 1-10.
To Next Page
Loading...
Need help?
General
