CLI Commands: Switching
CLI L2P
Release
7.0
05/2011
5.5
Redundant Coupling
457
5.5.3 ring-coupling config
This command sets the Ring Coupling configuration.
Possible values are:
D single Configure the Ring Coupling's basic setting to single (both cou-
pling ports are local to the switch, switch performs master and slave func-
tions).
D dual-master-inband Configure the Ring Coupling's basic setting to
dual-master-inband (2nd coupling port is on a remote switch, local switch
is master, communication over network).
D dual-master-outband Configure the Ring Coupling's basic setting to
dual-master-outband (2nd coupling port is on a remote switch, local
switch is master, communication over dedicated control port).
D dual-slave-inband Configure the Ring Coupling's basic setting to
dual-slave-inband (2nd coupling port is on a remote switch, local switch is
slave, communication over network).
D dual-slave-outband Configure the Ring Coupling's basic setting to
dual-slave-outband (2nd coupling port is on a remote switch, local switch
is slave, communication over dedicated control port).
D dmi Abbreviation for dual-master-inband.
D dmo Abbreviation for dual-master-outband.
D dsi Abbreviation for dual-slave-inband.
D dso Abbreviation for dual-slave-outband.
Default
none
Format
ring-coupling config <{ single |
dual-master-inband | dual-master-outband |
dual-slave-inband | dual-slave-outband |
dmi | dmo | dsi | dso }>
Mode
Global Config
To Next Page
Loading...
Need help?
General
