CLI Commands: Base
120
4.6
Management Commands
CLI L2P
Release
7.0
05/2011
4.6.28 network mgmt-access operation
This command is used to configure the restricted management access
feature (RMA).
It enables or disables the service to have management
access. The default value is disable.
Format
network mgmt-access operation {disable|enable}
Mode
Global Config
enable
Enable the restricted management access function globally.
disable
Disable the restricted management access function globally.
4.6.29 network mgmt-access status
This command is used to configure the restricted management access
feature (RMA).
It activates/deactivates an existing rule with <index>.
Format
network mgmt-access status <index>
{enable | disable}
Mode
Global Config
<index>
Index of the entry in the range 1..16.
enable
Allow the service to have management access.
disable
Do not allow the service to have management access.
To Next Page
Loading...
Need help?
General
