CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
153
4.6.68 snmptrap ipaddr
This command assigns an IP address to a specified community name. The
maximum length of name is 32 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is retained
and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr <name> <ipaddr> <ipaddrnew>
Mode
Global Config
ipaddr
Enter the old IP Address.
ipaddrnew
Enter the new IP Address.
To Next Page
Loading...
Need help?
General
