Hirschmann MACH 1000

CLI Commands: Base
150
4.6 Management Commands
CLI L2P
Release 7.0 05/2011
4.6.65 snmp-server enable traps port-sec
This command enables port security traps. When the traps are enabled, a
Port Security Trap is sent if a port security event occurs
(applies to MAC/IP Port Security as well as to 802.1X Port Security).
Default
enabled
Format
snmp-server enable traps port-sec
Mode
Global Config
U no snmp-server enable traps port-sec
This command disables Port Security traps.
Format
no snmp-server enable traps port-sec
Mode
Global Config