CLI Commands: Base
CLI L2P
Release
7.0
05/2011
4.6
Management Commands
131
4.6.43 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent
across a network to an SNMP Network Manager. These messages alert the
manager to events occurring within the switch or on the network. Six trap re-
ceivers are simultaneously supported.
Format
show snmptrap
Mode
Privileged EXEC
SNMP Trap Name
The community string of the SNMP trap packet sent to the trap man-
ager. This may be up to 32 alphanumeric characters. This string is
case sensitive.
IP Address
The IP address to receive SNMP traps from this device. Enter four
numbers between 0 and 255 separated by periods.
Status
A pull down menu that indicates the receiver's status (enabled or dis-
abled) and allows the administrator/user to perform actions on this
user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
To Next Page
Loading...
Need help?
General
