CLI Commands: Base
106
4.6
Management Commands
CLI L2P
Release
7.0
05/2011
<refresh-interval>.
Configure the IO-Module event logging for one or all digital outputs.
all Configure the IO-Module event logging for all digital outputs.
<slot/output> Configure the IO-Module event logging for a
single digital output.
disable Disable event logging for digital output status changes.
enable Enable event logging for digital output status changes.
snmp-trap
This command enables or disables the sending of SNMP traps in
case of output status changes for one or all digital outputs. Default:
disable.
The trap will be sent to all SNMP trap receivers configured with
snmptrap.
The output state will be checked according to the interval set with IO-
<refresh-interval>.
all Configure the IO-Module SNMP trap for all digital outputs.
<slot/output> Configure the IO-Module SNMP trap for a single
digital output.
disable Disable SNMP traps for digital output status changes.
enable Enable SNMP traps for digital output status changes.
To Next Page
Loading...
Need help?
General
