CLI Commands: Switching
CLI L2P
Release
7.0
05/2011
5.1
Spanning Tree Commands
423
(defined as the default CIST ID) is passed as the <mstid>, then the con-
figurations are performed for the common and internal spanning tree
instance.
This command accepts the value 0 for the mstid, meaning the common
and internal spanning tree.
If the ‘cost’ token is specified, this command sets the path cost for this
port within a multiple spanning tree instance or the common and internal
spanning tree instance, depending on the <mstid> parameter, to the
default value, i.e. a pathcost value based on the Link Speed.
If the ‘port-priority’ token is specified, this command sets the priority for
this port within a specific multiple spanning tree instance or the common
and internal spanning tree instance, depending on the <mstid> parame-
ter, to the default value, i.e. 128.
Format
no spanning-tree mst <mstid> <cost | port-priority>
Mode
Interface Config
To Next Page
Loading...
Need help?
General
