Hirschmann MACH 1000 Reference Manual

CLI Commands: Switching
CLI L2P
Release 7.0 05/2011
5.2 MRP
439
Manager Settings:
Display the Manager Settings for the current ARC configuration.
Admin Status
Display the ARC manager is enabled or disabled
Protocol
Display the Protocol. Possible values: mrp, ....
Port 1
Display the number of Ring Port 1 for the manager (slot/port).
Port 2
Display the number of Ring Port 2 for the manager (slot/port).
VLAN ID
Display the VLAN ID. Possible values: 0 - ....
Last Action Result
Display the Result of the Last Action.
Possible values: Ring is open, Already Configured, Loop Source,
Multiple RM, Configuration failed, Port not in full duplex mode, ARC
not supported by the ring devices.
Last Check result:
Display the Result of the last check.
- Nr: Display the number of the check result.
- Mac Address: Display the concerned MAC address.
- IP Address: Display the concerned IP address.
- Type: Display the type of the result. Possible values: Error,
Warning.
Possible check results (examples):
Error - Ring is open
Warning - Already Configured – HIPER Ring - Port1:
1.1 - Port2: 1.2
Warning - Already Configured - MRP - Port1: 1.9 -
Port2: 1.10 – VLAN ID: 0
Warning - Already Configured – Fast HIPER Ring -
Port1: 1.3 - Port2: 1.4
Error - Loop Source – Hop count: 1 - Port1: 1.1 -
Port2: 1.4 – Port3: 1.15
Error - Multiple RM – MRP

Hirschmann MACH 1000 Specifications

General

Brand	Hirschmann
Model	MACH 1000
Category	Switch
Language	English