Command Manual - Multicast
Quidway S2000 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
2-3
We can know from the information listed above that :
z
There is a multicast group in VLAN 2;
z
The router port is Ethernet 0/1;
z
The address of the multicast group is 230.45.45.1;
z
The member of the IP multicast group is Ethernet 0/12;
z
MAC multicast group is 0100-5e2d-2d01;
z
The member of the MAC multicast group is Ethernet 0/12.
2.1.3 display igmp-snooping statistics
Syntax
display igmp-snooping statistics
View
Any view
Parameter
none
Description
Using display igmp-snooping statistics command, you can view the statistics
information on IGMP Snooping.
This command displays the statistics information about IGMP Snooping of Ethernet
switch. It displays the information such as number of received general IGMP query
packets, received IGMP specific query packets, received IGMP Version 1 and Version
2 report packets, received IGMP leave packets and error packets, and sent IGMP
specific query packets.
For the related command, see igmp-snooping.
Example
# Display statistics information about IGMP Snooping.
<Quidway> display igmp-snooping statistics
Received IGMP general query packet(s) number:0.
Received IGMP specific query packet(s) number:0.
Received IGMP V1 report packet(s) number:0.
Received IGMP V2 report packet(s) number:0.
Received IGMP leave packet(s) number:0.