Command Manual - Security
Quidway S2000 Series Ethernet Switches Chapter 1 802.1x Configuration Commands
1-8
Description
Using dot1x port-method command, you can configure the base for 802.1x to perform
access control on the specified interface. Using undo dot1x port-method command,
you can restore the default access control base.
By default, the value is macbased.
This command is used to set the base for 802.1x to perform access control, namely
authenticate the users, on the specified interface. When macbased is adopted, the
user access this interface must be authenticated independently, and if one successful
authentication user is to finish network service, the other accessed users can still use
network service. When portbased is adopted, if only the first access user by this
interface can be authenticated successfully, the other access users followed can be
considered authenticated successfully automatically ,but if the first one finish the
network service , the other accessed users’ network service will be rejected . .
This command has effect on the interface specified by the parameter
interface-list
when executed in system view. It has effect on all the interfaces when no interface is
specified. The parameter interface-list cannot be input when the command is executed
in Ethernet interface view and it has effect only on the current interface.
For the related commands, see display dot1x.
Example
# Authenticate the supplicant based on the interface number on Ethernet 0/1.
[Quidway] dot1x port-method portbased interface Ethernet 0/1
1.1.8 dot1x quiet-period
Command
dot1x quiet-period
undo dot1x quiet-period
View
System view
Parameter
None
Description
Using dot1x quiet-period command, you can enable the quiet-period timer. Using
undo dot1x quiet-period command, you can disable this timer.
If an 802.1x user has not passed the authentication, the Authenticator will keep quiet
for a while (which is specified by quiet-period timer) before launching the authentication
To Next Page
Loading...
Need help?
General