Huawei Quidway S2000 Series User Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches Chapter 4 System Maintenance Commands
4-32
default log, trap and debugging settings in the records may be different with one
another. Use default configuration record if a module does not have any specific
configuration record in the channel.
Example
# Configure to enable the log information of VLAN module in SNMP channel and allows
the output of the information with a level higher than emergencies.
[Quidway] info-center source vlan channel snmp log level emergencies
4.5.12 info-center timestamp
Syntax
info-center timestamp { log | trap | debugging } { boot | date | none }
undo info-center timestamp {
log | trap | debugging }
View
System view
Parameter
log: Log information.
trap: Trap information.
debugging: Debugging information.
boot: Time elapsing after system starts. Format: xxxxxx.yyyyyy, xxxxxx is the high 32
bits of the elapsed time (in milliseconds) after system starts, and yyyyyy is the low 32
bits.
date: Current system date and time. It shows as yyyy/mm/dd-hh:mm:ss in Chinese
environment and mm/dd/yyyy-hh:mm:ss in Western language environment.
none: No timestamp format.
Description
Using info-center timestamp command, you can configure the timestamp output
format in debugging/trap information. Using undo info-center timestamp command,
you can disable the output of timestamp field.
By default, datetime stamp is used.

Huawei Quidway S2000 Series Specifications

General

Brand	Huawei
Model	Quidway S2000 Series
Category	Switch
Language	English